The Cigarette Lighter is held in position by the outer part of the body which should be unscrewed and removed. Place the remainder of the Cigarette Lighter through the hole from the front, replace outer body from the rear and tighten.
GUIDE TO WIRING:
(See illustration below) Always disconnect battery before working on vehicle electrical circuits.
1. Using the lead provided, connect terminal ‘A’ to a 12 volt power source protected by a 10 amp fuse. Ideally the circuit chosen should be controlled by the vehicles on-off ignition switch.
2. Connect terminal ‘B’ securely to a suitable earthing point.
NB IF YOU ARE IN ANY DOUBT WE RECOMMEND THAT YOU SEEK ADVICE FROM AN AUTO ELECTRICAN. FOR 12 VOLT DC USE ONLY