Classic Car Illuminated Cigarette Lighter 12Volt
	This Car Cigarette Lighter is supplied as a complete assembly and can be used as a replacement for an existing unit. It can also be fitted where a blanked hole is provided or, using a 23mm diameter hole, in any other suitable position on the dashboard. GUIDE TO FITTING The Cigarette Lighter is held in position by the outer part of the body which should be unscrewed and removed. Place the remainder of the Cigarette Lighter through the hole from the front, replace outer body from the rear and tighten. GUIDE TO WIRING (See illustration below) Always disconnect battery before working on cars electrical circuits. 1. Connect terminal ‘A’ to a 12 volt power source protected by a 10 amp fuse. Ideally the circuit chosen should be controlled by the vehicles on-off ignition switch. 2. Connect terminal ‘B’ securely to a suitable earthing point. 3. Connect the lead 'C' to the cars lighting circuit to illuminate the lighter when the side lights are on. NB IF YOU ARE IN ANY DOUBT WE RECOMMEND THAT YOU SEEK ADVICE FROM AN AUTO ELECTRICIAN FOR 12 VOLT DC USE ONLY